Jan 17, 2022 · Hi Guys, I've bought an Mavic Mini where the Ribboncable to the Gimbal Yaw motor driver board was broken/tattered. I've ordered an replacement cable and replaced it, all …

Jan 28, 2017 · You can cut the flat black ribbon cable on the gimbal and that will cut power to your gimbal motors. Dont cut the silver stranded cable, thats your video feed. If you decide to cut …

Jun 2, 2021 · Can I purchase a new gimbal, remove the camera module from it, and install my old camera into the new gimbal? That way, I have the paired camera in the new gimbal or is that …

Dec 17, 2020 · The gimbal before I was able to fix the focus and aperture issue was moving left/right & up/down just fine. It can fly normally, but again, the camera is facing forward non stop.

Apr 28, 2025 · Hi guys, I hope it’s the correct forum - DJI forum is useless. It’s my second time flying and the DJI flip camera keeps shaking. It’s as if the gimbal is...

Aug 23, 2017 · When I boot up my mini 2, the fly app says the gimbal is stuck when it isn’t. When it boots, the camera clearly does its boot Up sequence where it moves around and perform its …

Jan 17, 2019 · If your gimbal does not center after initial calibration, it means that your gimbal motor assembly is damaged. If you are getting the gimbal overload message it means that …

Jun 21, 2020 · Ended up going over the camera and gimbal with a magnifying glass and found the cause. The inner plate of the gimbal roll yoke hadn't been clipped into place properly on the …

Feb 9, 2021 · Hello everyone After changing the Gimball on Mavic mini1 and Power ON, the Gimbal is not in the correct position with DJI Fly screen messages: Incompatible...

Mar 27, 2024 · Hello! I have crashed Mavic 3 with following problems: -Gimbal unable to connect. Repairs required. Contact DJI Support for assistance (Code: 1d030001) -IMU initializing. …